A Cold Reset Printer for HP 2100

Performing a cold reset printer for HP 2100, see the procedures here:

1. Switch off the printer
2. Press and hold the “JOB CANCEL” button
3. Then switch on the printer
4. After all the LEDs on, release the “JOB CANCEL” button
5. A cold reset changes most system parameters in NVRAM to the factory defaults
6. The “JOB CANCEL” button must be released within 20 seconds
7. After all of the LEDs on, an NVRAM initialization is performed instead of a cold reset

Download Epson EasyPrint v3.10

Epson EasyPrint is a software utility that makes it easier for you to adjust printer settings. You can select printer settings right in the Print window, without having to click the Properties button. Epson EasyPrint is already included with Epson Smart Panel 3.2 and Epson Copy Utility 3.0. If you want to download the software here
source : epson.com

Resetting Canon Ink Cartridges for 4600

The first you should try refilling your cartridge, then ignoring the warnings. The cartridges is like the PGI-520BK for the pixma 4600 may have newer generation chips to prevent them from being refilled and used. In this case, you must replace the cartridge or its chip. Remember that ignore the warnings that appear when printing on it, after the first you have tried to refill your cartridge. 5MBRK3TZ3HPB

Free Download Reseter Epson CX5000

Read and take the following procedures. These are steps how to reset Epson CX5000;

1. Switch on printer
2. Run the reset.bat and follow the instruction
- set the date as indicated in the reset.bat
( if there is no date, then the resetter no need to change date )
- after set the date correctly just minimalize the reset.bat
3. run serviceFT.exe from the extracted folder
6. go to maintenance then Select waste ink pad counter then click ok
7. click on "check button" till its done then click on "initialization button" then click on "finish button"
8. switch off printer for 5secs then switch on again
9. After you reset successfully, go back in reset.bat windows and you can change the date back to default

Download the software, here

Reset Epson Stylus Photo RX510 Manually

Here the procedures how to reset the Epson Stylus Photo RX510 printer. The tip is should be taken if the printer shows “ERROR”. Read the steps and follow the procedures carefully:

• Connect the power cable into the socket
• Place the printer OFF or Standby
• Press and hold the buttons together: Power, Load / Eject, Stop, B & W, Color. It’s maybe about 5 seconds, then release them.
• See the display on the printer, if it shows “Init EEPROM” press the color button for 1 second, then the printer will be reset.
• Wait until the reset process is completed.
• Now, the printer is ready to use.

Reset Ink Counter - Level Canon iP1600 Manually

Here some procedures how to reset iP1600. Basically whole the ways rather same enough. These are manual methods:

1. Switch off the printer
2. Push and Hold down the Resume button, then press the Power button.
3. Keep holding down Power button and let Resume button go.
4. Press the Resume button 2 times then let BOTH buttons go.
5. The Green LED will flash and then stop blinking.
6. When green LED are solid, then press the Resume button 4 times.
7. Press the Power button and the printer should turn off, if not,
8. press the Power button once more.
9. Your printer should respond as normal
   

Resetting Instructions for EPSON CX1500

rHere some procedures how to use the reset tool of EPSON CX1500. Please follow the instructions correctly;

1. The first step,Switch on the printer
2. Then, run the program or .exe file
3. Choose the RD setting
4. Double Click on Dump Data Rom Data
5. Replace Protection Counter A to Zero (0)
6. Click Exit